Gradall 534B (9100-3023) Operation Manual Bedienungsanleitung

GeneralThe brake system furnished on the handler includesa service brake, parking brake and Mico lock.Because service braking and “inching” (slow trav

3. Pull Mico Lock lever back to lock position (leververtical) and then release brake pedal.To Release Mico LockRelease Mico Lock by pushing lever forw

GeneralThe drive train provides two and four wheel driveand includes the engine, torque converter,transmission, propel shaft and front and reardriving

The rear driving axle includes planetary hubs whichare powered by hydraulic motors mounted on theinner face of the hubs. Hydraulic flow to drivemotors

LevelingThe handler is designed to permit tilting main frameeight degrees to left or right to compensate foruneven ground conditions.A level indicator

AttachmentsAlthough the carriage/fork combination is mostfrequently used, a number of other attachments areavailable for use with the handler. A mater

This section highlights some common proceduresand discusses areas which may be new to even theexperienced operator.Hydraulic ControlsAll boom and atta

BOOM EXTENSION IN FEET FROM FRONT TIRE TO FORK FACEFIGURE SHOWN ARE STACKING CAPACITY TRUCK LEVEL.RATED LIFT CAPACITIES SHOWN ARE WITH MACHINE ON A FI

Material Handling Bucket CapacityLift capacity for a material handling bucket,iffurnished with the handler, is shown on theAttachment Capacity plate l

LUBRICATION & MAINTENANCE DIAGRAMLubrication NotesLubricate points indicated by dotted leaderson both sides of unit.Intervals shown are for normal

IMPORTANT SAFETY NOTICESafe operation depends on reliable equipment and proper operatingprocedures. Performing the checks and services described in th

At End of First Week Lube No. of

*Specific hydraulic fluid specifications are shown below.**Capacities are approximate - check level to be sure.Hydraulic Fluid Specifications:Grade, A

GeneralThis manual provides important information tofamiliarize you with safe operating procedures andoperator maintenance requirements for theGradall

3

Read and understand this manual, the GradallLoed/ Materials Handler Safety Manual and allinstructional decals and plates before starting,operating or

The standard cab is open on three sides and includesan overhead guard to provide protection fromfalling objects.A fully enclosed cab with Plexiglass w

Before removing filler caps or fill plugs, wipe all dirtand grease away from the ports. If dirt is allowed toCHECKS AND SERVICESBEFORE STARTING ENGINE

7Diesel engine ignition is accomplished by heatgenerated when fuel/air mixture is compressedwithin the cylinders. Because this heat may beinsufficient

Stopping the EngineOperate engine at idle speed for a few minutesbefore turning it off. This allows engine coolantand lubricating oil to carry excessi